DIY Dog Bathtub
When I first started grooming dogs for a living, I did it fast, so I didn’t have much time or money to get all the supplies I needed at the highest quality. Thank goodness we live in an area in which most people didn’t care what I was bathing their dog in!
My first bath tub was a true DIY. We purchased a livestock tub at a farm store in the city an hour away and used it just as it was, with a hole cut out of the bottom for a drain. One day we were out for a drive in the village and on a road near some cottages someone had put an old bathtub out for garbage. It was a small apartment sized tub – not a regular sized one – but it was perfect for my use.
So we took it and the DIY trough bathtub got put aside.
When we got our new dog – Ira – a Kuvasz, I knew eventually I would have to have a tub lower to the ground. At 5 months of age he was 55lbs and I couldn’t lift him into the high bathtub anymore by myself. So we made some modifications to the DIY trough bathtub so I could use it on a low grooming table that Ernie refashioned (will discuss that in a different post 😎)
Because we can’t lift Ira the Kuvasz into any tubs we have to get him to walk up a ramp or use a step to get into the tub. This means the tub had to be cut in the back in order to make it easy for him to do this. Hopefully he won’t have a problem after training wanting to enter the bathtub for a bath!
Ernie used a reciprocating saw to cut a section out of the end of the tub. The tub will sit on the low table when we need it.
He fashioned a drain out of left over pieces of plumbing supplies. It is a good idea to keep these things around just in case. And a good idea to learn how to figure things like that out.
The drain simply lets the water into a rubbermaid container underneath. This is all we have for now since there is no floor drain and the drain for the other tub is too high to allow for proper drainage.
Ernie also cut an old rubber tube in half that he had in his junk drawer and put it over the edge of the opening cut. This is where the dog will enter the tub.
When I am done wetting or rinsing the dog, I simply have to lift the bucket underneath into the other tub and dump it down the drain. Hopefully it won’t weigh more than 55 lbs! Actually, I’ll probably just use a smaller bucket to transfer water into the other tub until it is light enough to lift.
If you bath dogs a lot, it’s a good idea to put a catch over the drain to prevent too much hair from going down and plugging things up. As a pro groomer we are required by law to have that in place for our drains.
If you don’t have a drain for the water to go down, it could go out the bottom of the tub onto the ground, but this isn’t very eco-friendly. If possible make sure it goes into a manhole or sewer drain (which still isn’t perfect) but can be used if absolutely necessary.
The main thing about this tub is that it is not just on the ground and any dog that will be bathed in it will need to become accustomed to being in it and getting sprayed with water. If you do some work ahead of time with out water and with some yummy food almost any dog can learn to step up into the tub with no problem for the dog or you.
This tub could obviously be used for other pets and washing other things as well. The limits are only made by one’s imagination.
I prefer reusing things as much as possible. This is one way we do our part to be kind to nature. We have stuff and we don’t throw it out if at all possible. If we hadn’t used this for a bathtub it would definitely be used for something else. Maybe to grow plants in?
Happy Reusing Stuff!